3Com 2200 Switch User Manual


 
Remote Access Parameters 2-11
Example:
Do you want this to be the new default screen height?
(y/n):
y
Disabling the
Reboot and
Abort Keys
As shipped, the Administration Console allows you to use the [Ctrl + X] or
[Ctrl + C] key combinations within the Administration Console. These key
strokes allow you to reboot the system [Ctrl + X] or restart the
Administration Console [Ctrl + C]. You can change this setting to disable
both of these features.
CAUTION: If you disable the control keys, only use [Ctrl + C] if instructed to
by a Technical Support representative. Using [Ctrl + C] might irregularly
terminate an Administration Console session.
To enable or disable the reboot and abort control keys:
1 From the top level of the Administration Console, enter:
system ctlKeys
You are prompted for whether to enable or disable the functionality, as
shown here:
Enter new value (disabled,enabled) [enabled]:
2 Enter enabled or disabled at the prompt.
Remote Access
Parameters
You can reach the Administration Console remotely through a telnet or
rlogin session. You can set parameters to prevent disconnections when
another user remotely accesses the Administration Console, to enable the
Switch 2200 to end remote sessions after a specified time period, and to
specify the time interval before remote sessions are ended.
Preventing
Disconnections
Because only a single shell is supported by the Administration Console, you
might be disconnected from your session if someone else remotely accesses
the Administration Console. A terminal connected through the Console
serial port can be disconnected by a telnet or rlogin connection.
Top-Level Menu
system
ethernet
fddi
bridge
ip
snmp
analyzer
script
logout
display
softwareUpdate
baseline
consoleSpeed
telnet
password
name
time
screenHeight
consoleLock
ctlKeys
nvData
reboot