Filter
Top Products
Configuration Tasks
1-3
Save, restore, or reset nonvolatile data in the system
Provide a backup for nonvolatile data, restore nonvolatile data
to the system, or reset nonvolatile data to defaults.
system nvData
page 6-2
Reboot the system
Restart the system. Disconnects rlogin and telnet sessions.
system reboot
page 4-4
Table 1-2
System Management Setup Commands
Task Quick Command For Details, See. . .
Configure the Console port baud rate
Change the factory default baud rate of the Console port,
which allows you to connect a VT or tty type of terminal or
terminal emulator to the system using a null modem cable.
system consoleSpeed
page 3-2
Configure an IP address using an IP interface
Communicate with the system using SNMP, rlogin, or telnet.
ip interface display
ip interface define
ip interface modify
ip interface remove
page 3-5
Define static routes
Access a menu from which you can display, define, remove, and
flush static routes for transmitting traffic through the system.
Static routes override routes learned through RIP.
ip route
ip route default
page 3-9
Administer the ARP cache
Display, remove, and flush the ARP cache (a table of known IP
addresses and their corresponding MAC addresses).
ip arp display
ip arp remove
ip arp flush
page 3-11
Set RIP’s operational mode
Define how Routing Information Protocol (RIP) messages are
processed.
ip rip
page 3-12
Ping an IP station or the system
Find out if the system can reach an IP station or check that the
system is on the network.
ip ping
page 3-12
Display IP statistics
Display datagram statistics and current RIP operational mode.
ip statistics
page 3-14
(continued)
Table 1-1
General System Commands (continued)
Task Quick Command For Details, See. . .