1-4
C
HAPTER
1: S
UPER
S
TACK
™ II S
WITCH
2200 A
DMINISTRATION
O
VERVIEW
Configure SNMP management
Display current SNMP configurations and specify the type of
authorization for SNMP management.
snmp display
snmp community
page 3-15
Configure SNMP trap reporting
Display SNMP trap reporting information, add or modify trap
reporting destination configurations, remove trap destinations,
flush all SNMP trap reporting destinations, and set up SMT
event proxying.
snmp trap display
snmp trap addModify
snmp trap remove
snmp trap flush
snmp trap smtProxyTraps
page 3-16
Table 1-3
Bridging Commands
Task Quick Command For Details, See. . .
Display bridge information
Display information about the bridge, such as statistics, bridge
configurations, and spanning tree configurations.
bridge display
page 10-1
Enable or disable IP fragmentation
Enable or disable the fragmenting of large FDDI packets to
allow FDDI and Ethernet stations to communicate using IP.
bridge ipFragmentation
page 10-5
Enable or disable IPX snap translation
Enable or disable the translation of 802.3_RAW IPX packets to
FDDI_SNAP packets (when going from Ethernet to FDDI), and
vice versa (when going from FDDI to Ethernet). The default is
disabled.
bridge ipxSnapTranslation
page 10-5
Set the bridge address threshold
Specify the reporting threshold for the total number of Ethernet
addresses known to the bridge. The SNMP trap
addressThresholdEvent
is generated when the threshold is
reached.
bridge addressThreshold
page 10-6
Set the bridge address aging timer
Specify how often dynamically learned addresses are aged by
the bridge port. Appropriately configured aging prevents
packet flooding.
bridge agingTime
page 10-6
(continued)
Table 1-2
System Management Setup Commands (continued)
Task Quick Command For Details, See. . .