3Com 2200 Switch User Manual


 
1-2
C
HAPTER
1: S
UPER
S
TACK
™ II S
WITCH
2200 A
DMINISTRATION
O
VERVIEW
Table 1-1
General System Commands
Task Quick Command For Details, See. . .
Run a script of commands to set up a system
Write a script of Console commands with the values you assign
so that you can quickly configure one or more systems. You can
run the same script on a number of systems to ensure
consistent setup.
script
page 2-13
Display the system configuration
Display software and hardware revisions and certain warning
messages.
system display
page 4-1
Install software into flash memory
Update your system software. Software is initially installed at
the factory.
system softwareUpdate
SuperStack™ II Switch
2200 Software Installation
and Release Notes
Display, set, enable, or disable a baseline for statistics
Establish and use baselines for Ethernet, FDDI, and bridging
statistics to evaluate recent activity in your system and on your
network.
system baseline
page 5-2
Configure timeout for remote sessions
Configure the system to disconnect remote sessions after a
specified time interval.
system telnet
page 2-12
Control access to the Console
Set passwords for levels of access (read, write, administer) and
prohibit remote access during your session by locking the
Console.
system password
system consoleLock
page 4-2
page 3-20
Name the system
Assign the system a unique name for management purposes.
For example, you might name a system based on its location:
Switch2200-Floor2
.
system name
page 4-3
Set the system date and time
Ensure that messages are accurately logged. The internal clock
is set at the factory; change it for your time zone.
system time
page 4-3
Set screen height
Adjust the console screen height for your terminal.
system screenHeight
page 2-10
Enable the [Control] keys when working in the Console
Enable quick keys for the reboot (Ctrl+X) and abort (Ctrl+C)
functions.
system ctlKeys
page 2-11
(continued)