Filter
Top Products
12-24 CHAPTER 12: CREATING AND USING PACKET FILTERS
Unassigning
Packet Filters
from Ports
To unassign a packet filter from one or more ports, the packet filter must
have been previously assigned to at least one port.
To unassign a packet filter:
1 From the top level of the Administration Console, enter:
bridge packetFilter unassign
2 Enter the id number of the packet filter to unassign.
3 Enter the port type (
Ethernet, FDDI, all).
4 Enter the port number(s) of the packet filter to unassign.
5 Enter the path(s) of the packet filter to unassign.
An example of unassigning a packet filter is shown next. In this example,
the unassignment is from the transmit all (txA) paths on port 1.
Select filter [1-n]: 1
Select port type(s) (Ethernet,FDDI|all) [Ethernet,FDDI]: FDDI
Select port(s) (1-16|all) [1-16]: 1
Select path(s) (txA,txM,rxA,rxM|all) [txA,rxA]: txA
Because you can specify multiple selections at each level, you can assign a
wildcard that attempts to unassign the filter from the set indicated by the
ports and paths taken in combination.
One or more of the unassignments might fail if the filter is not assigned.
Top-Level Menu
system
ethernet
fddi
➧bridge
ip
snmp
analyzer
script
logout
display
ipFragmentation
ipxSnapTranslation
addressThreshold
agingTime
stpState
stpPriority
stpMaxAge
stpHelloTime
stpForwardDelay
stpGroupAddress
port
➧packetFilter
list
display
create
delete
edit
load
assign
➧unassign
addressGroup
portGroup