Filter
Top Products
85330A Multiple Channel Controller 7-5
Remote Programming Command Reference
Standard Command Reference
Standard Command Reference
The following pages describe 85330A multiple channel controller standard
commands.
ROUTe
Subsystem Command
Syntax
:CLOSe port,(@switch address [,switch address]);
:DELay <micro-seconds>;
:CONTrol <data>;
ROUTe:CLOSe
Closes individual switch states in direct control only. The parameters are the
switch port address, 1 or 2 and the switch address. The switch address is the
concatenation of the SCU address and the channel. Examples are provided
earlier in this chapter.
This command can also be used to set the TTL level of the rear panel AUX 2
connector before entering run-time mode.
Default All switch modules are set to channel 1. AUX 2 connector default is TTL
LOW.
Syntax ROUTe:CLOSe 1|2,(@ <switch address, or list of switch addresses>);
or
ROUTe:CLOSe 3,(@0|1);
Example OUTPUT 70918;”ROUT:CLOS 1,(@102);”
Closes SCU address 1 channel 2.
OUTPUT 70918;”ROUT:CLOS 3,(@0);”
Sets AUX 2 to TTL LOW before run-time.
NOTE Multiple switch address entries may be:
• Separated by commas if listing each switch address.
• Separated by a colon for starting and ending switch addresses. Switch
address lists may contain both comma and colon separators.