Filter
Top Products
User’s Guide
5-22 Troubleshooting and Maintenance
Symptom Corrective Action
Printer Will Not Switch Paths Change the Path Value to “Either” under M2: Forms
Control. (See Section 3.8 – 3.13).
Verify the Config feature in M10 matches the
configuration of the printer.
First Print Line Location is
Wrong
Readjust the first print line using the instructions in
Section 3.4.
Verify the forms thickness setting is correct for the form
being used.
Enable the High Impact feature under M4: Printer Control
(See Section 4.6 – 4.7)
Print Contrast on Last Sheet
is Too Light
Select an NLQ font listed in Section 3.4.
Printer is Too Noisy Enable Quiet Mode feature under the M8: Form
Thickness Control. (See Section 4.6 – 4.7).