Filter
Top Products
User’s Guide
Forms Handling 3-13
3.4 Top of Form Adjustment
(Adjusting First Printline Location)
When paper is loaded into the printer, the printer automatically positions the paper to print on
the first line of the form. If you need to change the location of the first print line, use the
Adjust Form key and proceed as follows:
1. To place the printer in Top-of-Form Adjust Mode, open the Keypad Door and press the
Adjust Form key. The form will advance until the bottom of the first print line is
positioned just above the tear off bar for viewing (Figure 3-9). (For units equipped
with cut sheet option, open the Top Access Cover and use the metal tear edge just
above the top rollers.)
2. Use the Value ▲ and Value ▼ keys to move the paper up or down to the position
desired for first line of type. The line directly above the tear bar will be the first print
line (Figure 3-9).
3. Press the Adjust Form key or close Keypad Door. The printer will reverse feed the
form back to print position.
4. This adjustment affects the Load feature and is automatically saved in memory for the
current profile and will apply the next time forms are loaded.
NOTE
Perform this adjustment immediately after
loading paper to determine where the first
line will print. Making this adjustment while
printing on the page allows fine alignment
without resetting line count.