Features and Profiles 4-15
Menu 2: Forms Control (Cont’d)
Printer Displays Values Description
Auto Time ###s 1
.
.
.
.
.
.
30
The time in seconds that the form will be in the
tear position after more data is sent to the
printer.
This feature works only when the Auto Tear
feature is ON.
HF: Pos crg x.x” 0.0”
0.1”
0.2”
.
.
.
9.8”
Specifies the position of the carriage, when the
Heavy Forms feature is enabled. The
maximum value is dependent on the current
value of the Horz Adj xxx/144” feature.
HF: xxxxxxxxxxxx
On Feed
> x.x”
0.0”
0.1”
0.2”
.
5.0”
On page
break
Disabled
Specifies when the Heavy Forms sequence is
initiated.
On a paper feed greater than x.x inches the
carriage is positioned to the location
specified by the HF:Pos crg x.x” feature.
The default = .5” which is 3 lines @6 LPI.
On a form feed (FF) or paper move that
crosses a forms boundary or bottom margin
(page break), the carriage will be positioned
to the location specified by the HF: Pos crg
x.x” feature.
Heavy forms sequence is disabled.
