Filter
Top Products
Touch Panel Accessories
14
1200V Modero Video Touch Panels
Installing CAT5 Suppression Ferrites
Before connecting the RJ-45 cables to the panel, install the necessary number of CAT5 Suppression
Ferrites (FIG. 13) to their appropriate locations. These ferrites come as part of the Installation Kits
mentioned in the previous Specification table (page 2). No tools are required for this installation.
1. The CAT5 Suppression Ferrite is housed within a plastic enclosure (shown in FIG. 12) with a latch
release on one side. Pull to release the latch and open the enclosure.
FIG. 12 Table Top Cable - Specification Elements
ELEMENT #1:
CONDUCTOR:
INSULATION:
COLOR CODE:
P2: WHITE/ORANGE, ORANGE
P3: WHITE/GREEN, GREEN
PAIR:
(TWISTED AT VARIED LAYS TO MINIMIZE CROSS TALK)
ELEMENT #2:
CONDUCTOR:
INSULATION:
COLOR CODE:
CABLE:
BINDER:
FINAL ASSEMBLY:
AXIS TO MINIMIZE DIAMETER
BINDER:
JACKET:
COLOR:
DIAMETER:
P4: WHITE/BROWN, BROWN
DRAIN WIRE:
SHIELD:
DESCRIPTION:
TWO 4/PAIR 24 AWG STRANDED TINNED COPPER,
POLYETHYLENE INSULATION, ELEMENT #2: 1/PAIR 18 AWG
STRANDED TNNED COPPER, PVC INSULATION AND FOIL
SHIELDED OVERALL PAPER BINDER AND FLEX-PVC JACKET.
9/PAIRS COMPOSITE CABLE CONSISTING OF: ELEMENT #1:
2 X 4/PAIRS: 24 AWG STRANDED COPPER
24 AWG 7/32 TINNED COPPER; OD .024" NOMINAL
.0075" WALL POLYETHYLENE; OD .039" NOMINAL
P1: WHITE/BLUE, BLUE
2 CONDUCTORS TWINNED LEFT HAND LAY
4/P CABLED LEFT HAND LAY (BLUE BINDER, ORANGE BINDER)
PAPER TAPE
1 PAIR: 18 AWG SHIELDED
18 AWG 16/30 TINNED COPPER; OD .046" NOMINAL
.010" WALL PVC; OD .066" NOMINAL
BLACK, RED
#22 7/30 TINNED COPPER
ALUM/POLYESTER TAPE (FOIL SIDE IN)
TWO ELEMENT #1 & ELEMENT #2 CABLED ON COMMON
CLOTH TAPE 25% OVERLAP
.045" WALL FLEXIBLE PVC,
BLACK MATT
.375 INCHES NOMINAL
NONEMARKING:
Each bundle of 4 twisted pairs includes a colored tape indicator for identification.
FIG. 13 Installing the CAT5 Suppression Ferrites
Release the latch to
open the plastic
enclosure.
Insert the CAT5
cable and close
the enclosure.
Push down on the
enclosure until it
snaps closed.
All 1200V-Series, VG-Series, and Table Top CV10 panels require the installation of
an appropriate number of CAT5 Suppression Ferrites when they use an RJ-45 cable
to feed an A/V signal from the breakout box.