Filter
Top Products
Touch Panel Accessories
28
1200V Modero Video Touch Panels
Installing an NXT-BP into the NXA-BASE/B
The battery base does not directly connect to a power supply, but rather receives its power directly from
the Modero panel, through the Panel Interface connector.
1. With the panel mounted on the battery base, open the battery compartment (FIG. 29) by pulling the
handle outwards. This compartment houses two NXT-BP batteries.
FIG. 28 NXA-BASE/B shown aligning with NXT panel
Panel Interface
connector
Alignment
pegs
Interface
connector
Captive
fasteners
(male)
Top view
Bottom view
(female)
Remove any connectors from the rear of the Modero NXT panel before continuing
with the installation of the batteries. Power can only be supplied after the batteries
have been installed.
FIG. 29 Battery installation procedure
Battery
Compartment
NXT-BP Battery #2
Battery
Connectors
Battery
Connector
Port
Interface
connector
FRONT
NXT-BP Battery #1
Battery #2
slot