Filter
Top Products
Touch Panel Accessories
23
1200V Modero Video Touch Panels
4. Remove the I/O connector plate by using a grounded Phillips-head screwdriver to remove the two
screws and slide the I/O connector plate away from the back box housing.
5. Unscrew the four pan-head Housing Screws from the rear of the NXD unit (FIG. 22) and gently
remove the outer housing. These four screws secure the back box to the internal panel casing.
Step 2: Install the new 802.11g mini-PCI Wireless card (NXD)
1.
Complete the procedures outline within Step 2: Install the 802.11g mini-PCI Wireless Card section
on page 19 and then continue with the following step.
Step 3: Install the new Compact Flash Memory card (NXD)
1.
Complete the procedures outline within Step 3: Install the Compact Flash Memory Card
upgrade section on page 21 and then continue with the following step.
FIG. 22 Location of the securing screws on an NXD panel
Unscrew these four Housing Screws
DO NOT
these
DO NOT REMOVE
REMOVE
panel
securing
screws
these panel
securing screws
to remove the back box. These make direct
contact with the black outer housing.
DO NOT REMOVE THE PANEL SECURING SCREWS. These screws secure the
LCD to the metallic casing.