Filter
Top Products
Touch Panel Accessories
29
1200V Modero Video Touch Panels
2. Install the NXT-BP battery. label-side down.
3. Align the battery connectors with the corresponding battery connector port (located inside the
battery compartment), as shown in FIG. 29.
4. Insert the NXT-BP battery until the connectors securely fit into the battery connector port.
5. Repeat steps 2 through 4 for the other battery.
6. Apply a small amount of pressure to close the battery compartment until the compartment latches.
After a few seconds, the panel will turn On and the AMX logo will appear (indicating the
panel is receiving power.
Charging the NXT-BP batteries with the NXA-BASE/B
1.
Follow the procedures from the previous sub-section to attach the NXT touch panel to the
NXA-BASE/B.
2. Insert each battery into the battery compartment shown in FIG. 29.
3. Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT Modero panel.
The charge status bargraph indicators, on the Battery Base page, indicate when the batteries
are fully charged.
NXT-CHG Battery Charger Kit (FG2255-50K)
The NXT-CHG Kit includes one charger and two batteries. The optional NXT-CHG Modero Power
Station (FIG. 30) is a two-slot, stand-alone battery charger that can be used to recharge up to two
NXT-BP batteries. The batteries are charged in the order they are inserted into the charger. The
NXT-CHG Slot 1 has the feature of being able to completely discharge and recharge (recalibrate) a
battery.
The NXA-BASE/B will only charge batteries when the NXT panel is in Sleep mode.
FIG. 30 NXT-CHG Kit (consists of one NXT-CHG charger and two NXT-BP batteries)
NXT-CHG Modero Power Station (charger)
NXT-BP Modero Power Pack (battery)
Battery Life indicator