Filter
Top Products
AT Command Set
A-30 Issue 2 November 1996
Command: &Y
Function: Designate the default configuration profile.
Type: configuration
Arguments: An argument of 0 will recall stored profile 0; an
argument of 1 will recall stored profile 1. Factory-default
selection is stored profile 0.
S-Register: none
Example: AT&Y1
Comments: In the example, the configuration profile stored in
location 1 will be recalled the next time that the 8400B
Plus Data Module is powered on. When the &Y
command is issued, the currently active profile does not
change until the 8400B Plus Data Module is powered
off and then on again.
See Also: "Configuration Parameters" on page 3-7 and the &V
command on page A-28.
Table A-1. Accepted AT Command Labels — Continued
Label Description
ENTER