Filter
Top Products
S-Registers
C-10 Issue 2 November 1996
Register: S3
Description: This S-register stores the ASCII value of the carriage
return character.
Range of Values: Value may be 000 through 127; factory-default setting
is 013, usually by the
or key or the
key combination from a data terminal.
Storable: no
Comments: This character serves as the command terminator on
an AT command line. It is also output following all result
codes.
See Also: "Command Line Set Up" on page 3-3.
Table C-1. Labels Used in S-Registers — Continued
Label Description
ENTER RETURN
CTRL
M