Filter
Top Products
S-Registers
Issue 2 November 1996
C-9
Register: S2
Description: This S-register stores the ASCII value of the escape
sequence character.
Range of Values: Value may be 000 through 127 (see comments);
factory-default setting is 043, the ASCII code for a plus
sign (+).
Storable: no
Comments: Setting the value greater than 127 will disable escape
sequence detection, in which case the escape
sequence cannot be used to move to command mode.
The operation of the Data Terminal Ready (DTR)
circuit, set by the &D command, can still be used to
move to command mode without disconnecting the call.
See Also: "From Data Mode to Command Mode and Back" on
page 3-10 and the &D command on page A-23.
Table C-1. Labels Used in S-Registers — Continued
Label Description