Filter
Top Products
88
SERIES II INTELLIGENT DATA/FAX MODEMS
Figure 5-2. On-line diagnostics information.
On or Off Hook H
You can make the Series II Modem hang up (go On Hook). Entering
ATH1<CR> brings the line Off Hook, just as if you picked up the
telephone set. You can hang up by entering ATH0 or ATH (the default
is 0 when no number is entered).
Escape Sequences- Entering Command Mode While Still
On-Line +++AT<CR>
It is possible to cause the Series II Modem to enter Command mode
after the modem has gone on-line with a remote modem without
disconnecting the call. This is done by entering an Escape Code. The
default Escape Code used by the Modem is three plus signs (+++)
followed by the letters A and T, up to sixty command characters (most
typically “H”, to hang up), and a RETURN. The number of command
characters allowed after +++ AT<CR> , is defined by S-Register S34.
S-Register S34 defaults to ten command characters.
024 2A71 0213
ONLINE DIAGNOSTICS
LINK TYPE V.34
LINE SPEED 28800/26400
SERIAL SPEED 19200
*********** ***********
ERROR CNTRL/COMPRESS LAPM
FALL BACK/FORWARD LOCALLY ENABLED
DATA FORMAT ASYCHRONOUS
SYMBOL RATE(SYMETRIC) 3429/3429
CARRIER FREQUENCY 1959/1959
TRELLIS ENCODER 4D 16-STATE/4D 16-STATE
PRECODING OFF/OFF
LINE TYPE DIAL UP
RECV. SIGNAL LEVEL -024.5 dBm
TRANS SIGNAL LEVEL -011 dBm
NUMBER OF RETRAINS 000
ROUND TRIP DELAY 0005 ms (MEANINGFUL IN V34 AND V32 MODE)
NEAR/FAR ECHO LEVEL -028.0/072.0 dBm
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 F12
File Edit Setup Perform Transfer Windows Help
00:04:55
Connected to device
MEWDEFFeb29, 96 4:50pm
DCD
CTS
DSR