Filter
Top Products
91
CHAPTER1: Specifications
These commands are listed below.
Enable/Disable Reading of Line Probe Information Commands:
%DP0
Do not read Line Probe information from DSP during handshake
(Default).
%DP1
Read Line Probe information from DSP during handshake.
Format of Line Probe (Graph or Table) Commands:
%DF0
Data is displayed in Graph format. Y axis is shown in dBms (Default).
%DF1
Data is displayed in Table format. Numeric values are displayed
150 Hz to 3750 Hz in 75-Hz increments.
Immediate Action Line Probe Commands:
To activate these commands first type +++AT<CR> (on-line escape
command while maintaining command mode), then type the Command
prefixed by an AT.
&RP
This command initiates a retrain that makes the processor read Line
Probe information. Valid only when on-line in V.34 mode.
L9 = Displays Signal Strength information.
L10 = Displays Signal to Noise Ratio information (SNR).
L11 = Displays noise information.