Filter
Top Products
8-81
Cisco TelePresence Multipoint Switch Release 1.1 Administration Guide
OL-12586-02
Chapter 8 Interoperability with Legacy Video Conferencing Devices
Configuring Cisco TelePresence Interoperability
Step 3 Enter the settings as indicated in Table 8-3 to configure the SIP trunk. Leave default settings for fields
not included in Table 8-3.
.
Step 4 Click the Save button at the bottom of the page.
Configuring CUVC for Cisco TelePresence Interoperability
After basic CUVC configuration has been completed and the unit has been connected to the host
network, you need to perform the following tasks to configure the CUVC for Cisco TelePresence
Interoperability:
• Verify that the MCU and EMP are running the correct software version.
–
Log into the CUVC Administration console and click the Media Processing tab.
–
Verify that the MCU is running Version 5.5.0.0.54:MP.
–
Verify that all EMPs are running Version 5.5.2.0.2:EMP.
• EMP resources must be available and the MCU service must be defined to use HD/SD Continuous
Presence with a Max Call Rate of 768 kbps or greater. “HD Switch Mode” is not supported. If you
choose a service configuration such as “HD Switched Video,” the cascade connection between
CTMS and CUVC will fail to connect.
Table 8-3 Route Pattern Configuration Settings
Field Required Setting
Pattern Definition
Route Pattern Yes Enter the route pattern, including numbers and
wildcards (do not use spaces); for example, for
NANP, enter 9.@ for typical local access, or
8XXX for a typical private network numbering
plan. The uppercase characters A, B, C, and D are
valid characters.
Note The portion of the route pattern’s digit
string sent to the CUVC must begin with
a valid service prefix as defined on the
CUVC.
Note See the “Wildcards and Special
Characters in Route Patterns and Hunt
Pilots” section in the Cisco CallManager
System Guide for more information about
wildcards.
Description — Enter a text string describing this route pattern.
Gateway/Route List Yes Select the SIP trunk that you created for CUVC.
Call Classification Yes Select OnNet.