Filter
Top Products
A-1
Cisco TelePresence System Release 1.4 Administrator’s Guide
OL-12586-02
APPENDIX
A
Command Line Interface (CLI) Commands
Initial Release: August 4, 2008, OL-12586-02
Tables of Contents
• “Introduction” section on page A-1
• “Starting a CLI Session” section on page A-1
• “CLI Command Basics” section on page A-2
• “Ending a CLI Session” section on page A-2
• “CTMS CLI Commands” section on page A-2
Introduction
This chapter explains how to use Cisco TelePresence Multipoint Switch (CTMS) Command Line
Interface (CLI) commands.
Starting a CLI Session
You can access the CTMS CLI through the physical console or remotely. If accessing the CTMS CLI
remote, use Secure Shell (SSH) from a personal computer or workstation to connect securely to CTMS.
Before you begin, be sure that you have the following information:
• CTMS IP address
• Admin ID and password
You will need this information to log into CTMS.
Note The admin ID and password can be changed from the default in the Cisco Unified Communications
Manager (Unified CM) for CTMS device page.
To start a CLI session: