Filter
Top Products
8-83
Cisco TelePresence Multipoint Switch Release 1.1 Administration Guide
OL-12586-02
Chapter 8 Interoperability with Legacy Video Conferencing Devices
Configuring Cisco TelePresence Interoperability
Figure 8-4 H.323 Configuration Screen
–
If you are using an H.323 Gatekeeper, define the Gatekeeper IP address and the Gatekeeper Port
as 1719.
–
If you are using an MCU as an H.323 trunk in Unified Communications, go to Advanced H.323
Settings on the CUVC Protocols configuration page and record the RAS port number and
Signaling Port parameter value. Use the Signaling Port value for the Unified Communications
H.323 Trunk Port definition.
• Configure CUVC meeting characteristics for Cisco TelePresence Interoperability. CUVC meeting
characteristics are configured individually using the service prefix. Service prefixes define the
CUVC meeting characteristics, and are defined on the CUVC Administration page under Services.
From the Automatic Service Definitions page under Services as shown in Figure 8-5, configure the
following attributes:
–
Max Call Rate: 768 Kbps
–
Max layout: 1x1
–
Supported image size up to: CIF