Filter
Top Products
Configuring Networking
Configuring Routing
Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide 39
3
Configuring Routing
Use the Routing page to configure the operating mode and other routing options
for your device.
Configuring the Operating Mode
To configure the operating mode:
STEP 1 Choose Networking > Routing.
STEP 2 In the Operating Mode field, select one of the following options:
STEP 3 Click Save.
Configuring Dynamic Routing
Routing Information Protocol (RIP) is an Interior Gateway Protocol (IGP) that is
commonly used in internal networks. It allows the router to exchange its routing
information automatically with other routers, and allows it to dynamically adjust its
routing tables and adapt to changes in the network.
Dynamic Routing (RIP) enables the device to automatically adjust to physical
changes in the network layout and exchange routing tables with the other routers.
The router determines the network packets’ route based on the fewest number of
hops between the source and the destination.
Gateway To set the device to act as a gateway.
(Recommended)
Keep this default setting if the device is hosting
your network connection to the Internet and is
performing routing functions.
Router (For advanced users only) To set the device to act
as a router.
Select this option if the device is on a network with
other routers.
Enabling the Router mode disables NAT (Network
Address Translation) on the device.