Filter
Top Products
Configuring Networking
Configuring IPv6
Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide 53
3
4 to 6 Tunneling
To configure 4-to-6 tunneling:
STEP 1 Select Networking > IPv6 > Tunneling.
STEP 2 In the 4 to 6 Tunneling field, check the Enable box.
STEP 3 Enter the local WAN IPv6 address on the device.
STEP 4 Enter the remote IPv6 address, or the IP address of the remote endpoint.
STEP 5 Click Save.
Viewing IPv6 Tunnel Status
To view IPv6 tunnel status:
STEP 1 Choose Networking > IPv6 > IPv6 Tunnels Status.
STEP 2 Click Refresh to display the most up-to-date information.
This page displays information about the automatic tunnel set up through the
dedicated WAN interface. The table shows the name of tunnel and the IPv6
address that is created on the device.
Configuring Router Advertisement
The Router Advertisement Daemon (RADVD) on the device listens for router
solicitations in the IPv6 LAN and responds with router advertisements as required.
This is stateless IPv6 auto-configuration, and the device distributes IPv6 prefixes
to all nodes on the network.
To configure the RADVD:
STEP 1 Choose Networking > IPv6 > Router Advertisement.
STEP 2 Enter this information:
RADVD Status Check Enable to enable RADVD.