Cisco Systems SCE 1000 2xGBE Network Router User Manual


 
Chapter 7 Basic SCE 1000 Platform Operations
Managing SCE 1000 Configurations
Cisco SCE 1000 2xGBE Installation and Configuration Guide
OL-7821-05 7-5
ip address 10.1.5.109 255.255.0.0
interface FastEthernet 0/1
interface FastEthernet 0/2
exit
line vty 0 4
no timeout
exit
SCE 1000#
Saving the Configuration Settings
When you make changes to the current running configuration and you want those changes to
continue to be valid when the system restarts, you must save the changes before leaving the
management session, that is, you must save the running configuration to the startup configuration
file.
The SCE platform provides multiple interfaces for the purpose of configuration and management.
All interfaces supply an API to the same database of the SCE platform and any configuration
made through one interface is reflected through all interfaces. Furthermore, when saving the
running configuration to the startup configuration from any management interface, all
configuration settings are saved regardless of the management interface used to set the
configuration.
To save configuration changes, complete the following steps:
Step 1 At the SCE 1000# prompt, type show running-config to view the running configuration.
The running configuration is displayed.
Step 2 Check the displayed configuration to make sure that it is set the way you want. If not, make the
changes you want before saving.
Step 3 Type copy running-config startup-config.
The system saves all running configuration information to the configuration file, which is used
when the system reboots.
The configuration file holds all information that is different from the system default in a file
called config.txt located in the directory: tffs0:system.
EXAMPLE:
The following example shows the running configuration file.
SCE 1000#show running-config
#This is a general configuration file (running-config).
#Created on 15:50:56 CET MON February 11 2006
#cli-type 1
#version 1
clock timezone CET 1
snmp-server community “public” ro
snmp-server host 10.1.1.253 traps version 1 “public”