Filter
Top Products
Chapter 7 Basic SCE 1000 Platform Operations
Performing Complex Configurations
Cisco SCE 1000 2xGBE Installation and Configuration Guide
OL-7821-05 7-7
Step 3 Type
copy tffs0:system/prevconf/config.tx1 tffs0:system/config.txt.
The system sets the startup configuration to the configuration from config.tx1.
EXAMPLE:
The following example displays a saved configuration file and then restores the file to overwrite
the current configuration.
SCE 1000#more tffs0:system/prevconf/config.tx1
#This is a general configuration file (running-config).
#Created on 19:36:07 UTC THU February 14 2006
#cli-type 1
#version 1
interface LineCard 0
no silent
no shutdown
interface FastEthernet 0/0
ip address 10.1.5.109 255.255.0.0
interface FastEthernet 0/1
interface FastEthernet 0/2
exit
line vty 0 4
exit
SCE 1000#copy tffs0:system/prevconf/config.tx1 tffs0:system/config.txt
SCE 1000#
Performing Complex Configurations
After you have installed your SCE 1000 platform hardware, checked all external connections,
turned on the system power, allowed the system to boot up, and performed the initial system
configuration, you might need to perform more complex configurations, which are beyond the
scope of this publication.
For further information on system and interface configuration, refer to the following documents:
• Cisco Service Control Engine (SCE) Software Configuration Guide
• Cisco Service Control Engine (SCE) CLI Command Reference