Filter
Top Products
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Cisco SCE 1000 2xGBE Installation and Configuration Guide
OL-7821-05 5-3
Initial System Configuration
Upon initial connection to the local terminal, as described above, the system configuration wizard
automatically runs to guide the user through the entire setup process. The wizard prompts for all
necessary parameters, displaying default values, where applicable. You may accept the default
values or define other values.
With the exception of the time settings, which take effect immediately when entered, the new
configuration is applied and saved only at the end of the dialog when approved by the user.
Therefore, if the setup dialog is aborted, no change takes place in the configuration, other than
time settings (if entered).
When the dialog is complete, you may review the new configuration before applying it. The
system displays the configuration, including parameters that were not changed. The system also
displays any errors that are detected in the configuration. When the configuration is satisfactory,
you may apply and save the new configuration.
The following table lists all the parameters included in the initial configuration. It is
recommended that you obtain values for any parameters that you will configure at this time before
beginning the setup.
Note
For further information regarding any configuration step or specific parameter, refer to the relevant
section in the Cisco Service Control Engine (SCE) Software Configuration Guide.
Setup Command Parameters
Table 5-1 Setup Command Parameters
Parameter Definition
IP address IP address of the SCE 1000.
subnet mask Subnet mask of the SCE 1000.
default gateway Default gateway.
hostname Character string used to identify the SCE 1000. Maximum 20 characters.
admin password Admin level password.
Character string from 4-100 characters beginning with an alpha character.
root password Root level password.
Character string from 4-100 characters beginning with an alpha character.
password encryption
status
Enable or disable password encryption?
Time Settings
time zone name and
offset
Standard time zone abbreviation and minutes offset from UTC.