Filter
Top Products
10. Use the disklabel utility to label the disks used to create the cluster
(Section 6.10).
11. Refer to the TruCluster Server Software Installation manual and install
the TruCluster Server software subsets and run the clu_create
command to create the first cluster member. Do not allow clu_create
to boot the system. Shut down the system to the console prompt
(Section 6.10).
12. Reset the bootdef_dev console environment variable to provide
multiple boot paths (Section 6.8). Boot the first cluster member.
13. Run clu_add_member on a cluster member system to add subsequent
cluster members.
Before you boot the system being added to the cluster, on the newly
added cluster member:
a. Use the wwidmgr utility with the -quickset option to set the
device unit number for the member system boot disk (Section 6.6.2).
b. Set the bootdef_dev console environment variable to one
reachable path to the member system boot disk (Section 6.6.3)
c. Boot genvmunix.
14. Create a new kernel, but do not reboot. Shut the system down and reset
the bootdef_dev console environment variable to provide multiple
boot paths to the member system boot disk (Section 6.8). Boot the new
cluster member system.
15. Repeat steps 13 and 14 to add other cluster member systems.
Consult the following documentation to assist you in Fibre Channel storage
configuration and administration:
• KGPSA-BC PCI-to-Optical Fibre Channel Host Adapter User Guide
(AA-RF2JB-TE)
• Compaq StorageWorks Fibre Channel Storage Switch User’s Guide
(AA-RHBYA-TE)
• Compaq StorageWorks SAN Switch 8 Installation and Hardware Guide
(EK-BCP24-IA/161355-001)
• Compaq StorageWorks SAN Switch 16 Installation and Hardware Guide
(EK-BCP28-IA/161356-001)
• Compaq StorageWorks HSG80 Array Controller ACS Version 8.5
Configuration Guide
• Compaq StorageWorks HSG80 Array Controller ACS Version 8.5 CLI
Reference Guide
Using Fibre Channel Storage 6–3