Filter
Top Products
P00>>> show dev
.
.
.
pga0.0.0.1.0 PGA0 WWN 1000-0000-c920-eda0
pgb0.0.0.2.0 PGB0 WWN 1000-0000-c920-da01
• You can use the wwidmgr -show adapter command as follows:
P00>>> wwidmgr -show adapter
item adapter WWN Cur. Topo Next Topo
[ 0] pga0.0.0.4.1 1000-0000-c920-eda0 FABRIC FABRIC
[ 1] pgb0.0.0.3.0 1000-0000-c920-da01 FABRIC FABRIC
[9999] All of the above.
• If the operating system is installed, the worldwide name of a KGPSA
adapter is also displayed in the boot messages generated when the emx
driver attaches to the adapter when the adapter’s host system boots. Or,
you can use the grep utility and obtain the worldwide name from the
/var/adm/messages file as follows:
# grep wwn /var/adm/messages
F/W Rev 2.20X2(1.12): wwn 1000-0000-c920-eda0
F/W Rev 2.20X2(1.12): wwn 1000-0000-c920-eda0
F/W Rev 2.20X2(1.12): wwn 1000-0000-c920-eda0
.
.
.
Record the worldwide name of each KGPSA adapter for later use.
6.5.3 Setting up the HSG80 Array Controller for Tru64 UNIX
Installation
This section covers setting up the HSG80 controller for operation with
Tru64 UNIX Version 5.0A and TruCluster Server Version 5.0A. For more
information on installing the HSG80, see the Compaq StorageWorks
HSG80 Array Controller ACS Version 8.5 Configuration Guide or Compaq
StorageWorks HSG80 Array Controller ACS Version 8.5 CLI Reference Guide.
To set up an HSG80 for TruCluster Server operation, follow these steps:
1. If not already installed, install the HSG80 controller(s) into the RA8000
or ESA12000 storage arrays.
2. If used, ensure that the external cache battery (ECB) is connected to the
controller cache module(s).
3. Install the fibre-optic cables between the KGPSA and the switch.
4. Set the power verification and addressing (PVA) ID. Use PVA ID 0 for
the enclosure that contains the HSG80 controller(s). Set the PVA ID to
2 and 3 on expansion enclosures (if present).
6–26 Using Fibre Channel Storage