Filter
Top Products
2. Press Enter to display the first submenu item in the configuration
menu, Ethernet IP address:
Ethernet IP address:
10.00.00.10
--
The underline cursor denotes the selected address field.
Use the up or down button to increase or decrease the displayed number.
Use the Tab/Esc button to select the next field. Modify the address
fields until you have the address set correctly.
3. Use Enter to accept the value and step to the next submenu item
(Ethernet Submask), and then repeat step 2 to set the Ethernet subnet
mask.
4. Press Enter to accept the Ethernet subnet mask.
5. Press the Tab/Esc button repeatedly to get back to the top-level menu.
6. Press the down button to select the Operation Menu:
Select Menu:
Operation Menu
7. If the switch is operational, place the switch off line before rebooting
or you will lose any transmission in progress.
Press Enter to display the first submenu in the Operation Menu, Switch
Offline:
Operation Menu:
Switch Offline
8. Press the down button until the Reboot submenu item is displayed:
Operation Menu:
Reboot
9. Press Enter. You can change your mind and not reboot:
Reboot
Accept? Yes No
10. Use the Tab/Esc button to select
Yes. Press Enter to reboot the switch
and execute the POST tests.
____________________ Note _____________________
After changing any configuration menu settings, you must
reboot the switch for the change to take effect.
Refer to the switch documentation for information on other switch
configuration settings.
Using Fibre Channel Storage 6–19