Filter
Top Products
To reconfigure TL895 SCSI bus configuration, follow these steps:
1. Remove the SCSI bus cable from one drive to be daisy chained.
2. Remove the terminator from the other drive to be daisy chained.
3. Ensure that the drive that will be the last drive on the SCSI bus has a
terminator installed.
4. Install a SCSI bus jumper cable (part number 6210567) on the open
connectors of the two drives to be daisy chained.
Figure 8–13 shows an example of a TL895 that has tape drives 1, 3, and 5
daisy chained to tape drives 2, 4, and 6 respectively.
Figure 8–13: TL895 Tape Library Internal Cabling
Robotics
Controller
SCSI ID 0
SCSI Port 5
SCSI Port 4
SCSI Port 3
Tape Drive 0
SCSI ID 1
Tape Drive 1
SCSI ID 2
ZK-1397U-AI
SCSI Port 8
SCSI Port 7
SCSI Port 6
SCSI Port 2
SCSI Port 1
Terminator
Terminator
Terminator
Terminator
PN 0415619
SCSI Jumper Cable
PN 6210567
Tape Drive 2
SCSI ID 3
Tape Drive 3
SCSI ID 4
Tape Drive 4
SCSI ID 5
Tape Drive 5
SCSI ID 1
Tape Drive 6
SCSI ID 2
Jumper
Cable
Jumper
Cable
Configuring a Shared SCSI Bus for Tape Drive Use 8–39