Compaq AA-RHGWB-TE Computer Hardware User Manual


 
Number of shared SCSI buses and the storage on each shared bus
Using shared SCSI buses increases storage availability. You can connect
32 shared SCSI buses to a cluster member. You can use any combination
of KZPSA-BB, KZPBA-CB, or KGPSA-BC/CA host bus adapters.
In addition, RAID array controllers allow you to increase your storage
capacity and protect against disk, controller, host bus adapter, and SCSI
bus failures. Mirroring data across shared buses provides you with more
reliable and available data. You can use Logical Storage Manager (LSM)
host-based mirroring for all storage except the clusterwide root (
/) file
system, the member-specific boot disks, and the swap and quorum disk.
No single-point-of-failure (NSPOF) TruCluster Server cluster
You can use mirroring and multiple-bus failover with the HSZ70, HSZ80,
and HSG80 RAID array controllers to create a NSPOF TruCluster Server
cluster (providing the rest of the hardware is installed).
Tape loaders on a shared SCSI bus
Because of the length of the internal SCSI cables in some tape
loaders (up to 3 meters), they cannot be externally terminated with a
trilink/terminator combination. Therefore, in general, with the exception
of the TL890, TL891, and TL892, tape loaders must be on the end of the
shared SCSI bus. See Chapter 8 for information on configuring tape
devices on a shared SCSI bus.
You cannot use Prestoserve in a TruCluster Server cluster to cache I/O
operations for any storage device, regardless of whether it is located
on a shared bus or a bus local to a given system. Because data in
the Prestoserve buffer cache of one member is not accessible to other
member systems, TruCluster Server cannot provide correct failover when
Prestoserve is being used.
Table 41 describes how to maximize performance, availability, and
storage capacity in your TruCluster Server hardware configuration. For
example, if you want greater application performance without decreasing
I/O performance, you can increase the number of member systems or you
can set up additional shared storage.
Table 41: Planning Your Configuration
To increase: You can:
Application performance Increase the number of member systems.
I/O performance Increase the number of shared buses.
Member system availability Increase the number of member systems.
Cluster interconnect availability Use redundant cluster interconnects.
TruCluster Server System Configuration Using UltraSCSI Hardware 43