Filter
Top Products
default for Parallel Mode is ECP.
To determine the correct mode to use, see the documentation that came with the device.
NOTE: The ECP setting also works for most software written for the AT and PS/2 modes. Devices that
use ECP mode may come with special drivers that need to be installed in order to use these modes.
Setting Parallel Mode to Disabled disables the parallel port and its assigned LPT address, freeing its
interrupt for another device to use.
For a change in the Parallel Mode option to take effect, you must reboot your computer.
Changing COM Ports
Serial Port allows you to map the address of the serial port to COM1 (the default), COM2, COM3,
COM4, or to disable the serial port and its assigned COM address, freeing that interrupt for another device
to use.
Enabling the IR Port
To enable the infrared (IR) port on the computer or docking device:
1. Set the Infrared Data Port option to COM1, COM2, COM3 (recommended), or COM4. The
default for Infrared Data Port is Disabled.
2. Set the Infrared Mode option to either Fast IR or Slow IR.
For a change in the Infrared Data Port option to take effect, you must reboot your computer.
Back to Contents Page