Filter
Top Products
180 Using the Storage Management Service
omconfig Enable Enclosure Alarm
Use the following omconfig command syntax to enable the enclosure alarm:
Complete Syntax
omconfig storage enclosure action=enablealarm controller=id
enclosure=<ENCLOSUREID>
where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure.
Example for SCSI, SATA, and ATA Controllers:
For example, to enable the alarm on the enclosure attached to connector 2 on controller 1, enter:
omconfig storage enclosure action=enablealarm controller=1
enclosure=2
Example for SAS Controllers:
For example, to enable the alarm on enclosure 2 attached to connector 1 on controller 1, enter:
omconfig storage enclosure action=enablealarm controller=1
enclosure=1:2
omconfig Disable Enclosure Alarm
Use the following omconfig command syntax to disable the enclosure alarm.
Complete Syntax
omconfig storage enclosure action=disablealarm controller=id
enclosure=<ENCLOSUREID>
where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure.
Example for SCSI, SATA, and ATA Controllers:
For example, to disable the alarm on the enclosure attached to connector 2 on controller 1, enter:
omconfig storage enclosure action=disablealarm controller=1
enclosure=2
Example for SAS Controllers:
For example, to disable the alarm on enclosure 2 attached to connector 1 on controller 1, enter:
omconfig storage enclosure action=disablealarm controller=1
enclosure=1:2