Filter
Top Products
262 Configuring System Information
Trap Manager
Use the Trap Manager menus to configure traps flags and view the trap log. Click System
→
Trap
Manager in the tree view to display the Trap Manager page. Use this page to go to the following features:
•Trap Flags
• OSPFv2 Trap Flags
• OSPFv3 Trap Flags
•Trap Log
Trap Flags
The Trap Flags page is used to specify which traps you want to enable or disable. When the condition
identified by an active trap is encountered by the switch, a trap message is sent to any enabled SNMP
Trap Receivers, and a message is written to the trap log.
To access the Trap Flags page, click System
→
Trap Manager
→
Trap Flags in the navigation tree.
Figure 6-118. Trap Flags