Filter
Top Products
698 Configuring Quality of Service
Table 11-5. Policy Class Configuration Commands
CLI Command Description
assign-queue Modifies the queue ID to which the associated traffic stream is
assigned.
conform-color Specifies for each outcome, the only possible actions are drop, set-cos-
transmit, set-sec-cos-transmit, setdscp-transmit, set-prec-transmit, or
transmit
drop Use the drop policy-class-map configuration command to specify that
all packets for the associated traffic stream are to be dropped at ingress.
mark cos Marks all packets for the associated traffic stream with the specified
class of service value in the priority field of the 802.1p header.
mark ip-dscp Marks all packets for the associated traffic stream with the specified IP
DSCP value.
mark ip-precedence Marks all packets for the associated traffic stream with the specified IP
precedence value.
match class-map Adds add to the specified class definition the set of match conditions
defined for another class.
match cos Adds to the specified class definition a match condition for the Class
of Service value.
match destination-address mac Adds to the specified class definition a match condition based on the
destination MAC address of a packet.
match dstip Adds to the specified class definition a match condition based on the
destination IP address of a packet.
match dstip6 adds to the specified class definition a match condition based on the
destination IPv6 address of a packet.
match dstl4port Adds to the specified class definition a match condition based on the
destination layer 4 port of a packet using a single keyword, or a numeric
notation.
match ethertype Adds to the specified class definition a match condition based on the
value of the ethertype.
match ip6flowlbl Adds to the specified class definition a match condition based on the
IPv6 flow label of a packet.
match ip dscp Adds to the specified class definition a match condition based on the
value of the IP DiffServ Code Point (DSCP) field in a packet.
match ip precedence Adds to the specified class definition a match condition based on the
value of the IP.
match ip tos Adds to the specified class definition a match condition based on the
value of the IP TOS field in a packet.