Filter
Top Products
Configuring IPv6 617
Table 10-2. IPv6 Interface Routing Commands
CLI Command Description
ipv6 address Configures an IPv6 address on an interface (including tunnel and
loopback interfaces).
ipv6 enable Enables IPv6 routing on an interface (including tunnel and loopback
interfaces) that has not been configured with an explicit IPv6 address.
ipv6 host Defines static host name-to- ipv6 address mapping in the host cache.
ipv6 mtu Sets the maximum transmission unit (MTU) size, in bytes, of IPv6
packets on an interface.
ipv6 nd dad attempts Sets the number of duplicate address detection probes transmitted
while doing neighbor discovery.
ipv6 nt managed-config-flag Sets the “managed address configuration” flag in router
advertisements.
ipv6 nd ns-interval Sets the interval between router advertisements for advertised
neighbor solicitations.
ipv6 nd other-config-flag Sets the “other stateful configuration” flag in router advertisements
sent from the interface.
ipv6 nd prefix Sets the IPv6 prefixes to include in the router advertisement.
ipv6 nd ra-interval Sets the transmission interval between router advertisements.
ipv6 nd ra-lifetime Sets the value that is placed in the Router Lifetime field of the router
advertisements sent from the interface.
ipv6 nd reachable-time Sets the router advertisement time to consider a neighbor reachable
after neighbor discovery confirmation.
ipv6 nd suppress-ra Suppresses router advertisement transmission on an interface.
show ipv6 traffic Shows traffic and statistics for IPv6 and ICMPv6.
show ipv6 vlan Displays IPv6 VLAN routing interface addresses.