Filter
Top Products
668 Configuring IPv6
•
Interface Delay Interval (secs)
— The OSPF Transit Delay for the virtual link in units of seconds. It
specifies the estimated number of seconds it takes to transmit a link state update packet over this
interface.
Displaying OSPFv3 Virtual Link Summary Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• OSPFv3 Commands
The following table summarizes the equivalent CLI commands for this feature.
OSPFv3 Route Redistribution Configuration
Use the OSPFv3 Route Redistribution Configuration
page to configure route redistribution.
To display the page, click IPv6
→
OSPFv3
→
Route Redistribution Configuration in the tree view.
Figure 10-29. OSPFv3 Route Redistribution Configuration
The OSPFv3 Route Redistribution Configuration page contains the following fields:
•
Source Protocol
— Select the type of source routes to configure for redistribution by OSPF. Valid
values are Static and Connected.
•
Metric
— Sets the metric value to be used as the metric of redistributed routes. This field displays the
metric if the source was pre-configured and can be modified. Valid values are 0 to 16777214.
•
Metric Type
— Sets the OSPF metric type of redistributed routes.
Table 10-23. OSPFv3 Virtual Link Summary Commands
CLI Command Description
show ipv6 ospf virtual-link brief Displays the OSPFV3 Virtual Interface information for all areas in the
system.