Filter
Top Products
Installing System Components 121
3
Pull back slightly on the retention standoff tab at the front edge of the
card and gently lift the card off the retention standoff. See Figure 3-19.
As the holder releases from the standoff, the connector under the card
disengages from the system board connector.
4
Angle the card so that the notch on the card slips through the clip
on the system board.
5
Close the system. See "Closing the System" on page 86.
6
Place the system upright on a flat surface.
7
Reattach any peripherals and connect the system to an electrical outlet.
8
Turn on the system and attached peripherals.
iDRAC6 Enterprise Card (Optional)
Installing an iDRAC6 Enterprise Card
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 85.
3
Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer" on page 87.
4
Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 88.
5
Remove the plastic filler plug for the iDRAC6 Enterprise port from
the system back panel.
6
Angle the card so that the RJ-45 connector fits through the back-panel
opening. See
Figure 3-20.
7
Align the front edge of the card with the two front plastic retention
standoffs next to the iDRAC6 Enterprise connector on the system board,
and lower the card into place. See Figure 3-20.
book.book Page 121 Wednesday, August 19, 2009 4:40 PM