Filter
Top Products
134 Installing System Components
4
Connect the battery cable to the connector on the storage card and replace
the storage controller card. See "Installing an Expansion Card" on page 115.
5
Replace the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer" on page 87.
6
Close the system. See "Closing the System" on page 86.
7
Place the system upright on a flat surface.
8
Reattach any peripherals and connect the system to an electrical outlet.
9
Turn on the system and attached peripherals.
Chassis Intrusion Switch
Removing the Chassis Intrusion Switch
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2
Open the system. See "Opening the System" on page 85.
3
Disconnect the chassis intrusion switch cable from the connector on
the system board. See Figure 3-26.
4
Slide the chassis intrusion switch out of the securing bracket notch.
book.book Page 134 Wednesday, August 19, 2009 4:40 PM