Filter
Top Products
About Your System 51
Unable to launch
System Services
image. System
halted!
System halted after
F10 keystroke because
System Services image
is either corrupted in the
system firmware or has
been lost due to system
board replacement.
Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server Configurator
user documentation for more
information.
The iDRAC6 Enterprise
card flash memory may
be corrupted.
Restore the flash memory
using the latest version on
support.dell.com. See the
iDRAC6 user's guide for
instructions on performing a
field replacement of the flash
memory.
Unexpected
interrupt in
protected mode
Improperly seated
memory modules or
faulty keyboard/mouse
controller chip.
Reseat the memory modules.
See "Troubleshooting System
Memory" on page 155. If the
problem persists, see
"Getting Help" on page 177.
Unsupported CPU
combination
Unsupported CPU
stepping
detected
Processor is not supported
by the system.
Install a supported processor.
See "Processor" on page 126.
Unsupported
DIMM detected.
The following
DIMM has been
disabled: x
Invalid memory
configuration. The system
will run but with the
specified memory
module disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 108.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
book.book Page 51 Wednesday, August 19, 2009 4:40 PM