Filter
Top Products
96 Installing System Components
Figure 3-10. Removing or Installing a Cabled Hard Drive
5
Detach the hard-drive bracket from the hard drive by pushing out at the
edges of the bracket and removing the hard drive.
NOTE: If you are not replacing the hard drive, remove the drive from the drive
bracket (see Figure 3-11) and insert the empty bracket back into the drive bay.
6
Replace the system cover. See "Closing the System" on page 86.
7
Place the system upright on a flat surface.
8
Reattach any peripherals and connect the system to an electrical outlet.
9
Turn on the system and attached peripherals.
1 power/data cable 2 tabs (2)
3 hard drive 4 hard-drive bracket
1
2
4
3
book.book Page 96 Wednesday, August 19, 2009 4:40 PM