Filter
Top Products
132 Installing System Components
13
Close the system. See "Closing the System" on page 86.
14
Place the system upright on a flat surface.
15
Reattach any peripherals and connect the system to an electrical outlet.
16
Turn on the system and attached peripherals.
17
Enter the System Setup program to confirm that the battery is operating
properly. See "Entering the System Setup Program" on page 58.
18
Enter the correct time and date in the System Setup program's
Time
and
Date
fields.
19
Exit the System Setup program.
RAID Battery (Optional)
Removing the RAID Battery
The information in this section applies only to systems with the optional
PERC controller card.
1
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 85.
3
Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer" on page 87.
4
Remove the storage controller card. See "Removing an Expansion Card" on
page 118.
5
To disconnect the RAID battery cable from the connector on the storage
card, press the tab on the RAID battery cable connector, and gently pull
the cable connector out of the connector on the storage card.
See Figure 3-25.
6
Pull the battery carrier release tab, and lift the battery carrier out of the
battery carrier slots on the chassis. See Figure 3-25.
7
Pull back gently on the two tabs holding the RAID battery and lift the
RAID battery from the battery carrier. See Figure 3-25.
book.book Page 132 Wednesday, August 19, 2009 4:40 PM