Filter
Top Products
34 About Your System
E1810 Hard drive ##
fault. Review
& clear SEL.
The specified hard drive
has experienced a fault.
See "Troubleshooting a
Hard Drive" on page 160.
E1812 Hard drive ##
removed.
Check drive.
The specified hard drive
has been removed from
the system.
Information only.
E1A14 SAS cable A
failure.
Check
connection.
SAS cable A is missing
or bad.
Reseat the cable. If the
problem persists,
replace cable.
If the problem persists,
see "Getting Help" on
page 177.
E1A1D Control panel
USB cable not
detected.
Check cable.
USB cable to the
control panel is
missing or bad.
Reseat the cable. If the
problem persists,
replace cable.
If the problem persists,
see "Getting Help" on
page 177.
E2010 Memory not
detected.
Inspect
DIMMs.
No memory was
detected in the system.
Install memory or reseat
the memory modules.
See "Installing Memory
Modules" on page 111 or
"Troubleshooting System
Memory" on page 155.
E2011 Memory
configuratio
n failure.
Check DIMMs.
Memory detected, but is
not configurable.
Error detected during
memory configuration.
See "Troubleshooting
System Memory" on
page 155.
E2012 Memory
configured
but unusable.
Check DIMMs.
Memory configured,
but is unusable.
See "Troubleshooting
System Memory" on
page 155.
Table 1-2. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 34 Wednesday, August 19, 2009 4:40 PM