Filter
Top Products
Chapter 7 Servo Parameters|ASDA-B Series
7-18 Revision January, 2009
Keypad Parameters
Control
Mode
Parameter Name Function Default Unit
P S T
P8-00★
KVER Keypad Firmware Version
Factory
setting
N/A
{ { {
P8-01 KFUN
Keypad Communication and Reset
Setting
1 N/A
{ { {
P8-05 KADR Communication Address Setting (Drive) 255 N/A
{ { {
P8-06 KBRT Transmission Speed (Keypad) 1 bps
{ { {
P8-07 KPTL Communication Protocol (Keypad) 0 N/A
{ { {
P8-08 KCMM Communication Selection (Keypad) 0 N/A
{ { {
P8-09 KTST Keypad Hardware Testing 0 N/A
{ { {
P8-10 KBLT LCD Backlight Display 0 N/A
{ { {
P8-11 KCLR Memory Block Clear 0 N/A
{ { {
P8-12 KRNO
Memory Block Position Number
(ROMx)
0 N/A
{ { {
P8-13★
KBL0
Status of Memory Block (ROMx)
0 N/A
{ { {
P8-14★
KBL1
Firmware Version of Memory Block
(ROMx)
0 N/A
{ { {
Explanation of symbols (marked after parameter)
(★) Read-only register.
(▲) Parameter cannot be set when Servo On (when the servo drive is enabled).
(●) Parameter is effective only after the servo drive is restarted (after switching power off and on).
(■) Parameter setting values are not retained when power is off.