Filter
Top Products
Chapter 7 Servo Parameters|ASDA-B Series
Revision January, 2009 7-71
2: LED testing.
3: Dynamical memory testing (RAM). The testing time is approx. 18 seconds.
4: Data memory testing (EEPROM). The testing time is approx. 140 seconds.
This parameter is used to test the hardware of the keypad. Since the life of the data memory is
limited and using this parameter will consumed the life of data memory, it is not recommended to
use this parameter and change the factory default setting if not necessary.
P8 - 10 KBLT LCD Backlight Display Communication Addr.: 080AH
Default: 0 Related Section: N/A
Applicable Control Mode: P/S/T
Unit: N/A
Range: 0 ~ 1
Settings:
0: OFF. LCD backlight is going off.
1: ON. LCD backlight is going on.
P8 - 11
KCLR Memory Block Clear Communication Addr.: 080BH
Default: 0 Related Section: N/A
Applicable Control Mode: P/S/T
Unit: N/A
Range: 0 ~ 124
Settings:
ASD-PU-01A
ASD-PU-01B