Filter
Top Products
set passthrough
Chapter 2 Command Descriptions 155
Using the “set service” command with IP Pass-through
You can use the “set service” command to have a network service
terminate both at a port on the Digi Cellular Family device and a different
port on the connected device. For example, you could have the Digi
Cellular Family device terminate the SSH service on port 2222, and the
connected device terminate SSH at port 22. To do so, you would issue a
“set service” command to move the SSH server from listening on port 22 to
listening on port 222. With such a configuration, both the Digi Cellular
Family device an the connected box could respond to SSH.
Syntax Configure IP pass-through mode
set passthrough [state={enabled|disabled}]
[http={pass|terminate}]
[https={pass|terminate}]
[telnet={pass|terminate}]
[ssh={pass|terminate}]
[snmp={pass|terminate}]
[connectware={pass|terminate}]
[surelink={pass|terminate}]
[ping={pass|terminate}]
Display current IP pass-through mode settings
set passthrough
Options state={enabled|disabled}
Enables or disables IP Pass-through.
http={pass|terminate}
Specifies whether the HTTP network service is configured to pass to the
connected device or terminate at the Digi Cellular Family device for
purposes of managing it, known as a pinhole.
https={pass|terminate}
Specifies whether the HTTPS network service is configured to pass to the
connected device (“pass”) or terminate at the Digi Cellular Family device
for purposes of managing it, known as a pinhole (“terminate”).
telnet={pass|terminate}
Specifies whether the Telnet network service is configured to pass to the
connected device (“pass”) or terminate at the Digi Cellular Family device
for purposes of managing it, known as a pinhole (“terminate”).
ssh={pass|terminate}
Specifies whether the SSH network service is configured to pass to the
connected device (“pass”) or terminate at the Digi Cellular Family device
for purposes of managing it, known as a pinhole (“terminate”).
snmp={pass|terminate}
Specifies whether the SNMP network service is configured to pass to the
connected device (“pass”) or terminate at the Digi Cellular Family device
for purposes of managing it, known as a pinhole (“terminate”).