Filter
Top Products
revert
Chapter 2 Command Descriptions 61
revert
Devices
supported
This command is supported in all Digi Connect products.
Purpose Sets a particular group of a devices’ settings to its default values.
The “revert” command keywords are used one at a time to revert one group
of settings. You cannot enter several keywords on a single command to
revert multiple settings.
If you enter “revert user,” “revert group,” or “revert permissions,” a message
is displayed indicating that those settings cannot be reverted individually,
and instead must be reverted all together at the same time via the “revert
auth” command. The “revert auth” command (revert authentication and
authorization) reverts all users, all groups, and all permissions at the same
time.
Required
permissions
No “set permissions” option is required for all “revert” command variants
except “revert all.” The permissions used by the various “set” commands
apply to the various “revert” command variants. “revert all” uses a different
mechanism that bypasses the individual “set” commands, and therefore
has its own permissions. To execute the “revert all” command, a user must
have permissions set to “set permissions revert-all=execute”. See
"set permissions" on page 157 for details on setting user permissions for
commands.
Syntax revert [all|
accesscontrol|
alarm|
auth|
autoconnect [port=range]|
bsc|
buffer [port=range]|
ddns|
dhcpserver|
ekahau
forwarding|
gpio|
host|
ia|
idle|
login|
menu|
mesh|
mgmtconnection|
mgmtglobal|
mgmtnetwork|
nat|
network|
passthrough|
pmodem [port=range]|
pppoutbound [port=range]|
profile [port=range]|