Filter
Top Products
set autoconnect
Chapter 2 Command Descriptions 81
set autoconnect
Devices
supported
This command is supported in Digi Connect Family and Digi Cellular
Family products only. Not supported in ConnectPort Display.
Purpose Used to establish an automatic connection (autoconnection) between the
serial port and a remote network destination, and to display current
autoconnect settings.
Required
permissions
For Digi Connect products with two or more users, to use this command,
permissions must be set to one of the following:
• For a user to display autoconnect settings for the line on which they are
logged in: “set permissions s-autoconnect=r-self”
• For a user to display autoconnect settings for any line:
“set permissions s-autoconnect=read”
• For a user to display and set the autoconnect settings for the line on
which they are logged in: “set permissions s-autoconnect=rw-self”
• For a user to display autoconnect settings for any line, and set the
autoconnect settings for the line on which the user is logged in:
“set permissions s-autoconnect=w-self-r”
• For a user to display and set the autoconnect settings on any line:
“set permissions s-autoconnect=rw”
See "set permissions" on page 157 for details on setting user permissions
for commands.
Syntax Configure autoconnect
set autoconnect [port=range]
[state={on|off}]
[trigger={always|data|dcd|dsr}]
[service={raw|rlogin|ssl|telnet}]
[description={string}]
[ipaddress=ipaddress]
[ipport=ipport]
[connect_on_string=string]
[flush_string={on|off}]
[keepalive={on|off}]
[nodelay=on|off]
Display autoconnect settings
set autoconnect [port=range]