Filter
Top Products
set udpserial
Chapter 2 Command Descriptions 219
ipport=ip port
The UDP port of the destination to which data is sent.
Options for displaying current UDP serial settings
port=range
Used to specify the serial port. Optional on a single-port device.
range=range
Identifies the range of UDP destinations to be displayed.
Examples Set general UDP serial forwarding based on bytes received
In this example, the amount of bytes received from the serial port will cause
the data to be sent on to the network destination.
#> set udpserial port=1 state=on sendcount=2
Set UDP destinations for a given serial port
In this example, data will be sent to the destination identified.
#> set udpserial port=1 range=1 ipaddress=10.0.0.1 ipport=2101 active=on
Display current UDP serial settings
The following are all valid ways of using set udpserial to display current
UDP serial settings:
#> set udpserial
#> set udpserial port=1
#> set udpserial port=1 range=1-12
See also • "revert" on page 61.
• "show" on page 249.