Filter
Top Products
set socket_tunnel
Chapter 2 Command Descriptions 201
Options state={disabled|enabled
Enables or disables the configured socket tunnel.
timeout={0|seconds}] {0 is no timeout}
The timeout (specified in seconds) controls how long the tunnel will
remain connected when there is no tunnel traffic. If the timeout value is
zero, then no timeout is in effect and the socket tunnel will stay up until
some other event causes it to close.
from_hostname={name|ip address}
The initiating host: the hostname or IP address of the network device that
initiates the socket tunnel.
from_port=port number
The initiating port: the port number that the Digi device uses to listen for
the initial socket tunnel connection.
from_protocol={tcp|ssl}
The initiating protocol: the protocol used between the device that initiates
the socket tunnel and the Digi device. Currently, TCP and SSL are the
two supported protocols.
to_hostname={name|ip address}
The destination host: The hostname or IP address of the destination
network device.
to_port=port number
The destination port: the port number that the Digi device uses to make
a connection to the destination device.
to_protocol={tcp|ssl}
The destination protocol: the protocol used between Digi device and the
destination device. Currently, TCP and SSL are the two supported
protocols. This protocol does not need to be the same for both
connections.
See also • "revert" on page 61.
• "show" on page 249.
• The section on socket tunnel settings in your Digi product’s User’s
Guide.